Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGate Company in Seabrook, TX
Gate work in Seabrook doesn’t follow the same playbook as inland Houston. The salt air off Galveston Bay, the older waterfront homes with original wrought iron, and the newer gated subdivisions all pull a gate in different directions. When a gate stops opening or a hinge starts grinding, the fix usually comes down to how long the hardware has been fighting the coastal air. Call us at (325) 378-0676 and we’ll give you a written price before any work starts.
Why Seabrook Homes Are Different
Two things separate Seabrook from everywhere else we work. First is the bay. Salt spray and humidity sit on gate hardware all year, and we see hinges, latch boxes, and control boards corrode faster here than almost anywhere in the region. A gate that works fine in Friendswood can show rust bloom and failing limit switches in Seabrook inside three or four years. We recommend marine-grade stainless steel hinges and latches for anything facing the water, and we stock them on the trucks that serve this area.
Second is the mix of housing. The mid-century waterfront homes along Todville Road and the streets off NASA Parkway often still have their original steel or wrought iron gates, which are built solidly but showing decades of stress at the weld points and hinge barrels. The newer subdivisions east of Highway 146 lean toward LiftMaster and FAAC operators with keypad and intercom entry. Both need a different approach, and the price should reflect that, not some flat rate off a board.
Styles & brands we work with
Our Main Seabrook Services
These are the three jobs Seabrook homeowners call about most. Each one has its own page with specifics, local pricing, and what to expect on the service call.
Gate Repair in Seabrook
The majority of what we fix in Seabrook comes down to coastal wear. A gate that drags on the driveway, a hinge that’s seized up from rust, a welded joint that’s cracked, or a keypad that stopped talking to the operator. We’ll come out, diagnose what’s actually wrong, and put the price in writing before we turn the first bolt. The repair carries a 365-Day Done Right Promise: if it fails inside that year, we return and fix it at no charge. Full details on the Gate Repair in Seabrook page.
Gate Installation in Seabrook
Installing a new gate on the water side of Seabrook means choosing the right metal before you choose the style. Powder-coated aluminum holds up best against salt air; bare steel looks good for about eighteen months and then starts telling you about it. We measure the opening, set the posts deep enough for the soil near the bay, and hang the gate with marine-grade hardware from the start. A written quote comes first, every time. See the Gate Installation in Seabrook page for what a full install includes.
Electric Gate Repair in Seabrook
Electric gates fail in Seabrook for two quiet reasons: corrosion in the control board connections and humidity in the actuator. We open the operator box, test the board and the safety sensors, check the actuator for moisture, and replace what’s actually failed rather than quoting you a whole new system because it’s easier. Our techs service LiftMaster, FAAC, BFT, and Linear operators daily, so the parts we need are usually in the truck. Estimated pricing and common symptoms are on the Electric Gate Repair in Seabrook page.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Brands We Service in Seabrook
We carry parts locally for LiftMaster, FAAC, BFT, and Linear operators, which covers most of the motorized gates in Seabrook. That means we can usually complete the repair the same day without waiting on a parts shipment. You can see the full lineup on our brands page.
See the difference
Before
After
Before
After
Before
AfterPricing for Gate Company in Seabrook, TX
| Service | Typical range in Seabrook |
|---|---|
| Service call & diagnosis | $75 – $140 |
| Hinge replacement (standard steel) | $180 – $400 |
| Hinge replacement (marine-grade stainless) | $240 – $520 |
| Latch or lock replacement | $120 – $300 |
| Weld repair (cracked joint, on site) | $150 – $450 |
| Gate adjustment & alignment | $140 – $320 |
| Swing gate actuator replacement | $650 – $1,400 |
| Control board replacement | $300 – $800 |
| Safety sensor replacement | $180 – $380 |
| Keypad or intercom replacement | $220 – $550 |
What pushes cost up in Seabrook is usually corrosion. A hinge that looks like a simple swap can turn into a post repair if the salt air has eaten the mounting plate. That’s also why we show you the written price before we start, after we’ve seen the actual gate, not a photo of one like it. The number we write down is the number you pay.
Neighborhoods We Serve in Seabrook
We work throughout Seabrook, from the older waterfront streets near the bay to the gated communities and newer builds off Highway 146. Our techs are usually on a Seabrook job within a day of your call, often the same day for a gate that won’t close.
- The Waterfront District and Todville Road corridor
- El Lago area and streets off NASA Parkway
- Lake Cove and the bay side off Repsdorph Road
- Kirby Woods and neighborhoods off Kirby Road
- The newer subdivisions east of Highway 146
Service Area – Cities Near Seabrook
Our Seabrook crews also cover the neighboring communities across the Clear Lake area. If you’re in League City, TX, Dickinson, TX, Friendswood, TX, or South Houston, TX, we can schedule a visit and give you the same written price promise. Dispatch is coordinated from our Houston office, but the technician who arrives at your gate serves Seabrook locally.
Serving Seabrook, TX - Our Local Coverage Area
We’re based in the Seabrook area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Company in Seabrook
For a gate that won’t open or won’t close, we can usually reach most of Seabrook the same day or next morning. A live person answers our phone around the clock, so you’ll know your arrival window before you hang up.
If your Seabrook property is in a gated community with design guidelines, the HOA may need to approve the gate style or material. We’ll advise you on what to ask and can provide the written quote your HOA board will ask for. The repair work itself usually doesn’t need approval.
It does. We replace more rusted hinges, seized actuators, and corroded control boards in Seabrook than anywhere else we work in the Clear Lake area. The right material choice on the front end, marine-grade stainless steel or powder-coated aluminum, extends a gate’s life by years out here.
It covers the repair. If the fix we make fails within 365 days, we come back and make it right at no charge. The guarantee is written on your invoice, not just spoken, so there’s no argument about what was promised.
If your gate is giving you trouble in Seabrook, calling is the fastest way to get a straight answer. We’ll give you a written price before any work starts, and a live person answers at (325) 378-0676 any hour, any day. Estimates are free.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Seabrook Customers Say
"Our intercom and gate motor both quit. They fixed the whole system in one visit and explained the warranty clearly. On time, polite, and tidy. Can't ask for more."
- Yvette Marchetti"Electric gate kept doing its own thing, opening at random. The tech found a shorted sensor and a worn board, fixed both, and showed me the old parts. Price was what he quoted on the phone."
- Cassandra Pike"Installed a new gate for us after the old wooden one rotted out. Clean work, showed up on time both days, and the written price didn't change. It swings perfectly."
- Donna Kirkpatrick